User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Introduction– 30
•
•
•
•
•
•
11 Figure - AUX-ODU-LPU-G
Optional indoor/outdoor Lightning Protection Unit for Infinet Wireless systems designed to withstand the toughest
conditions and protect the outdoor or the indoor unit from sudden power surges induced by lightning strikes. It
provides the same level of protection as AUX-ODU-INJ-G. AUX-ODU-LPU-G is compatible with all Infinet Wireless
devices.
Despite the fact every Infinet Wireless unit has a built-in lightning protection, AUX-ODU-LPU-G, thanks to its
superior GR-1089-grade protection, greatly reduces the risk of replacing damaged devices operating in harsh
environments or difficult-to-reach locations.
Parameter Description
Size and Weight 34x94x121 mm, 0.28 kg
Connectors and Interfaces ETH IN - Ethernet input
ETH OUT - Ethernet output (protected leg)
GND - Ground clamp
Supported Ethernet Modes 10/100/1000 Mbps (Gigabit Ethernet pass-through)
Water and Dust Protection IP66 and IP67
NOTE
The device is not supplied by default and must be ordered separately.