User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Link Pre-configuration in the lab– 40
•
•
•
•
•
Go to the "Settings" → "Security" section and configure:
Login (e.g., admin).
Password (e.g., admin).
5.3 Step 3: Firmware upgrade
Let's upgrade each unit to the latest stable firmware version. In case the laptop has an access to the Internet, a new
software version will be detected automatically, update on both devices.
Otherwise, the manualfirmware upgrade process should be performed:
Download latest release from the ftp serverftp://ftp.infinet.ru/pub/Firmware.
In the "Maintenance" section click the "Select file" button and set the path to the downloaded file, or drug it
to the specified area.
File will be uploaded to the device.Changes will take force after reboot.
5.4 Step 4: Radio parameters configuration
Let'sconfigure the minimumneededradio parameters to establish the link.
At the unit named Master at step #2 above,go to the"Settings" →"General" section and set the "Link ID"
parameter, it must bethe same on both sides of the link. Then to "Radio" and set this unit with:
NOTE
At the next login, type "admin" for the Login and Password (if these are the credentials set before) to
access the unit in the privileged mode.