User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Installation– 43
•
•
•
•
•
•
•
•
6 Installation
Mounting kit(see page 43)
Cable Gland Assembly (see page 47)
Mounting(see page 48)
Grounding and Lightning Protection (see page 52)
Antenna Alignment (see page 59)
6.1 Mounting kit
MONT-KIT-85 Mounting kit (see page 43)
MONT-KIT-85P Mounting kit(see page 44)
Mounting kit for Q5-18, Q6-18(see page 46)
6.1.1 MONT-KIT-85 Mounting kit
MONT-KIT-85 is supplied with models Q5-25,Q5-23, Q5-E,Q6-25, Q6-E by default.
It allows to make reliable and
easy installation of the unit with two-axis adjustment.Assemble the Mounting kit according to the scheme below.
The nut must be tightened until the spring washer clicks, without over-tightening.
Mounting is carried out on a pole with a diameter 30-85 mm. There are also possible options for mounting on a wall
or pole with a diameter more than 85 mm.