User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Installation– 46
Mounting is carried out on a pole with a diameter 30 ... 85 mm. There are also possible options for mounting on a
wall or pole with a diameter more than 85 mm.
6.1.3 Mounting kit for Q5-18, Q6-18
Q5-18,Q6-18 model installation is performed using bracer and threaded rod M6x90 thats supplied by default.
Installthe device according to the scheme below. The nut must be tightened until the spring washer clicks, without
over-tightening.
NOTE
Clamps and other optional fasteners are not included in the mounting kit MONT-KIT-85P.