User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Installation– 60
6.5.2 Alignment tool
Use the Alignment tool to point and optimize the antenna in the direction of maximum link signal. The built-in
graphical antenna alignment tool displays the signal levels for both devices and both polarizations, this makes an
alignment process fast and accurate.
A green marker indicates the current signal level. To achieve the best performance, this marker should be as close
as possible to the pale green area values, which displays the maximum calculated value possible for this link. A gray
marker indicates the maximum value that was reached on this channel.