User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 62
•
•
•
•
•
•
•
•
•
•
•
•
7 Operation & Administration
Web GUI Access(see page 63)
Dashboard(see page 64)
General settings(see page 68)
Security settings(see page 70)
Radio settings(see page 73)
Network settings (see page 78)
Switch Settings(see page 79)
SNMP settings(see page 82)
Spectrum Analyzer (see page 89)
Antenna Alignment Tool (see page 90)
Maintenance (see page 91)
Inst ant DFS(see page 93)
To make changes in the device configurationclick the "Changes" button in the upper right corner of the web
interface.
21 Figure - Applying changes
The "Applying global changes" window contains a table of parameters whose values have been changed by the
user. If you want to undo one change, click the "Roll back" button near the entry. If you need to undo all changes,
use the "Roll back" button at the bottom of the window. Changes will be saved to the device configuration by
clicking the "Apply" button.