User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 63
22 Figure - Applying changes
7.1 Web GUI Access
Web User Graphical Interface (Web GUI) - is the basic way to configure and operate a wireless unit.
WANFleX OSstarts automatically when you power on the unit,Web GUI is enabled by default. In order to access the
unit via Web browser, type an IP addressin the address bar.
NOTE
Сonnecting third-party equipment via Ethernet (switches, PCs), make sure the PoE, Energy Efficient
Ethernet and Green Ethernet functions are disabled on the network interfaces connected to Infinet
devices.
NOTE
By default any username and any password can be used to login Web GUI.
It's strongly recommended to set permanent username and password after the first log in. In order to do
this go to the "General settings(see page 68)" section.