User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 65
7.2.2 Wired interface
In the "Wired interface" tab, the Ethernet interface status can be monitored, as well as duplex mode and traffic load
for reception and transmission.The wired interface statistic is available on the right side, it can be reset by the
"Clear counters" button.
25 Figure - Wired interface paraqmeters
Parameter Description
Runt packets Packets less than 64 bytes in size
Oversize packets Packets larger than 9038 bytes
FCS errors Packets dropped due to checksum mismatch. The possible reasons for the error counter
increasement are described in the "Troubleshooting (see page 97)" article
Port overflow
errors
Packets dropped due to port buffer overflow
7.2.3 Wireless link status
The “Radio” tab displays the current settings of the wireless connection, as well as the link load in the uplink and
downlink directions.