User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 69
28 Figure - Unit parameters
7.3.2 SNTP
Starts the SNTP time synchronization service.For proper operation, specify the SNTP server time zone and the IP
address first. By default, the SNTP service is disabled.
Parameter Description
SNTP
Server
Address
The SNTP server IP address, the SNTP service will synchronize the time on the device with. The
device must have network access to the SNTP server.
Time Zone The time zone at the place of device installation. For example: GMT + 5.
8 SNTP parameters description
29 Figure - SNTP settings
7.3.3 Syslog
Allows to transmit syslog data to the server using the "syslog" protocol.Specify the syslog server address where
data should be transmitted.