User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 73
•
•
•
•
7.4.5 Radio authentication settings
Units at both ends of the wireless link should authorize each other before link establishment.Access key must be up
to 64 characters long, without spaces andmust be the same at both ends of the link.
35 Unit parameters description
7.5 Radio settings
The "Radio settings" section allows to configure radio parameters to establish wireless connection.
Radio settings are divided into the following categories:
Radio frontend(see page 73)
Air frame(see page 75)
Automatic modulation and transmit power control(see page 77)
Frequency channel grids(see page 77)
7.5.1 Radio frontend
Parameter Description
Unit role One units must be set to Master and the other one to Slave.