User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 80
7.7.2 QoS
Enable/disable prioritization strategy. Unit will recognize the 802.1p tags in Ethernet frame headers. Based on these
tags priorities will be autlomatically assigned to the frames when they are sent over the radio interface. After
transmission over radio interface frames with tags are sent to Ethernet. Priorities may be adjusted manually if a
VLAN based switching is enabled.
7.7.3 VLAN based switching
VLAN based switching allows to create list of allowedVLANsand their handling on the unitswitch plane. IfVLAN
basedswitching is enabled but no VLANs are added, device ports will allow untagged traffic only.Each entry of list
establishes the relationship between VLANIDandports VLAN modes. "VLAN1" is created by default andcould not
be deleted, it's enough to set all interfaces to "off" mode to disable it.