User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 82
•
•
•
•
7.7.3.1 Connectivity matrix
Allows to configure the traffic transfer between the network ports of the device.Configuration is performed visually
using switches.The green switch indicates allowed connections, the red one - denied.
Traffic flow betweenports is performed in accordance with VLAN modes set, if the VLAN based switching is enabled.
7.8 SNMP settings
SNMP allows the administrator to gather information about key device parameters and wireless links, including
information about changes.The use of any monitoring system helps to timely receive information about the
network infrastructure state using Infinet devices.Currently, the devices family supports SNMP protocol versions v1
v2cand v3.
TheSNMPProtocol has two branches, the agent and the management stations:
The agent sends data to the management station.Monitoring system - provides data gathering from all
agents in the network.
The monitoring system receives and processes events.
The information is passed through requests and replies with the use of theMIB.
The management station ormonitoring system is responsible for decoding theSNMPpackets and providing
an interface to the administrator.
7.8.1 General settings
This section allow to enable/disable SNMP protocol support.