User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 83
40 Figure - General SNMP settings
Paramete
r
Description
Enabled Enable/disable the SNMP service in the device.
Contact
person
A reference information about the device owner.
Location The geographical location where the unit is installed, used as a reference information about
thephysical device’s location.
7.8.2 SNMP v1/v2c
41 Figure - SNMP v1/v2c configuration
Paramete
r
Description
Enabled Enable/disable theSNMP v.1 and v.2c support. The first version of the SNMP protocol lacks
security, that hinders its use for network management, so SNMP v.1 and v.2c operates in read-only
mode. Enabled by default.