User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 85
•
•
•
Paramete
r
Description
Security Security level:
"No auth / No privacy"– the lowest security level without authentication and privacy, only
Username needs to be set. This level of protection does not allow management via the
monitoring system.
"Auth / No privacy"– middle level with authentication but without privacy, Username and
Password are required.
"Auth / Privacy"– highest level with authentication and privacy, Username, Password,
Privacy Password and Privacy Protocol should be set.
Readonly Enable/disable the read-only mode, readonly is set by defaut.
Admin Enable/disable the full access to all parameters, for example, the ability to reboot the device. By
default an access is limited.
Privacy
password
Set the privacy password, it is necessary when privacy is enabled for the required security level.