User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 89
•
•
Para
mete
r
Description
Port Set the monitoring system UDP port.
7.9 Spectrum Analyzer
In the "Spectrum Analyzer" menu, you can perform a deep analysis of the radio emissions in the environment where
the unit is placed. The unit scans the radio spectrum on all available frequencies. In order to obtain the information
as accurate as possible, the scanning process may take a while.
46 Figure - Spectrum analyzer result
The following parameters are available in order to operate the Spectrum Analyzer:
Parameter Description
Start
Frequency
Set the first frequency for scanning (in MHz).
Stop Frequency Set the last frequency for scanning (in MHz).