User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 93
"Download current configuration" button, the configuration can be loaded by clicking the "Upload configuration"
button,or you can drag and drop a file from your file manager into the dotted area.
7.11.5 Diagnostic card
In situation then helps of Infinet Wireless technical support team is required, the diagnostic card is necessary tool
which helps to detect and solve an issue faster and more effective. Click on "Download" button to create diagnostic
card.
7.12 Inst ant DFS
This section allows to monitor the Instant DFS tool operation in real time.To display the data in this section, the
frequency selection must be set to "Instant DFS" or "Instant DFS and radar detection" mode.To enable the required
mode, go to the "Radio(see page 73)" section.