User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Troubleshooting – 98
If there is no power, it is necessary to check the power supply, connectors, the Ethernet cables integrity.
8.1.3 Access to the unit recovery
If the power indicator is on and there is connection via the Ethernet interface, connect to the device directly as it is
shown in the scheme below.Make sure that the IP address of the PC is in the same subnet as the IP address of the
device.You can restore the IP address and reset the device to the factory settings using the ERConsole utility.