User's Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Quanta 5
Quanta 5 Technical User Manual
65
7.4.2 Radius AAA
Here you may configure a device access control using a remote RADIUS server.
Parameter Description
Address Set the RADIUS server IP address.
Port Set the RADIUS server port.
Secret Set the server password.
Radius server parameters description
Figure - RADIUS parameters
7.4.3 Command line interface
Allows to enable / disable remote device control by the command line using Telnet and SSH
protocols.
SSH (Secure Shell) protocol provides secure remote control to network devices. Its functionality
is similar to the Telnet protocol, but, unlike Telnet, SSH encodes all protocol messages,
including transmitted passwords. By default, only access via Telnet is enabled.
Figure - Access protocols