User's Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Quanta 5
Quanta 5 Technical User Manual
72
7.5.3 Automatic modulation and transmit power control
Parameter Description
AMC
strategy
There are following AMC strategies available:
Normal - represents a balance between the error rate and throughput
values.
Conservative - assumes using higher CINR thresholds in order to
minimize the error rate.
Agressive - lowers the thresholds in order to use higher modulation levels
and thus increase the throughput.
Disabled - disables automatic modulation control.
Automatic
transmit
power
control
ATPC allows to control transmitter output power automatically based on target
RSSI value. If actual RSSI level is lower then unit increases transmitter output
power of the remote unit and vice versa. ATPC could not set value that may
exceed the "Power limit" value.
The Master unit manages the transmit power of Slave unit.
The Slave unit manages the transmit power of Master unit.
Target
RSSI
RSSI value which will be used by ATPC as target.
AMC and ATPC settings description
Figure - AMC and ATPC settings