User's Manual
Table Of Contents
- Table of contents
- I. Getting Started
- II. Hardware description
- III. Installation procedure
- 1. Installation preparations
- 2. InfiNet Wireless R5000-Omx/Omxb
- 3. InfiNet Wireless R5000-Lmn
- 4. InfiNet Wireless R5000-M/Mm and R5000-Smn/Smnb/Smnc
- 5. Mounting kit (MOUNT-KIT-85)
- 8. InfiNet Wireless R5000-Smnc
- II. Configuration (Web-interface)
- III. Configuration (CLI)
- IV. Link setup
- V. Lost password recovery
- VI. Recommendations
- VII. Supplementary information
59
Copyright © 2004-2012 by InfiNet Wireless
System Settings
This section contains general system parameters:
• Device name – general device name
• User Name – user name (Login) used to access the unit management
interfaces
• Password – password used with the user name specified above
• Confirm Password – password confirmation
• Keep current system password – saves currently used password in the unit
configuration and locks Password and Confirm Password fields. In case
these fields are empty, and the check-box is unchecked a possible
vulnerability exists, as some browsers may put random data into the
Password/Confirm Password fields without user consent, making the unit
unaccessible after the configuration has been applied.
• WEB Interface language – permanently defines the web interface locale,
this choice would be used for all successive sessions (refer to the
Localization section earlier in this chapter for tips on per-session locale
changes).
SNTP and Time Zone settings:
• Start SNTP – starts SNTP service
• SNTP IP Address - sets SNTP server IP-address
• Time Zone – sets Time Zone. For more details on time zones please visit:
http://en.wikipedia.org/wiki/Time_zone.