User's Manual
Table Of Contents
- Table of contents
- I. Getting Started
- II. Hardware description
- III. Installation procedure
- 1. Installation preparations
- 2. InfiNet Wireless R5000-Omx/Omxb
- 3. InfiNet Wireless R5000-Lmn
- 4. InfiNet Wireless R5000-M/Mm and R5000-Smn/Smnb/Smnc
- 5. Mounting kit (MOUNT-KIT-85)
- 8. InfiNet Wireless R5000-Smnc
- II. Configuration (Web-interface)
- III. Configuration (CLI)
- IV. Link setup
- V. Lost password recovery
- VI. Recommendations
- VII. Supplementary information
60
Copyright © 2004-2012 by InfiNet Wireless
Network Settings
This section contains parameters related to network operation:
• ethX settings – Ethernet interface settings (e.g. eth0):
o Up enables/disables the interface
o DHCP allows DHCP client operation on the current interface
o Mode enables automatic or manual speed and duplex setup for the
Ethernet interface. Recommended setting is Auto.
o IP-address field allows user to assign an IP-address to the Ethernet
interfcace. Click the button to assign alias addresses or click Х
button to remove existing aliases.
o Description field can be used to add a text note to the interface
config (up to 72 characters).
• rfX Settings - RF interface settings (e.g. rf5.0). Same as the Ethernet
settings described above.