User's Manual

63
Copyright © 2004-2012 by InfiNet Wireless
• TX Power – configures transmitter power output. Enabling the ATPC
(Automatic Transmitter Power Control) system is strongly recommended.
The offset parameter is used to adjust the thresholds.
• Node Name – configures node name. This name will appear on the
neighbor lists
• Trap gateway – enables/disables SNMP trap relay
• Authentication mode – configures the authentication mode used by the
unit: public or static. Please refer to the WANFleX OS user manual,
“Node Authentication” section, for more information.
The Current Settings panel contains the RF channel parameters:
• Channel Width (MHz) – RF link channel width in MHz.
• Frequency (MHz) – central operating frequency in MHz.
• Frequency Range List – available only when the DFS system is enabled,
this parameter allows users to list frequencies available for DFS
operation.
• TX Bitrate (Kbps) – this setting controls the link bitrate. Enabling
automatic bitrate selection is strongly recommended. The offset
parameter is used to adjust the Autobitrate system thresholds.
• Channel Type – selects channel mode:
• Dual – MIMO (recommended)
• Single – MISO
• The Greenfield checkbox enables/disables Greenfield mode. This feature
optimizes the frames, transmitted via the RF link, boosting link
performance by 10-15%
• Network SID – Network System Identifier (up to 8-digit HEX figure). All
units that belong to the same wireless network segment must have the
same SID value.
• Node ID – the sequential number for the node. The parameter is optional.
• Security Key – a key word used to encode protocol messages. This key
can be up to 64 characters long and should not contain spaces. All units
that belong to the same wireless network segment must have the same
Security Key.
Static Links