User's Manual
Table Of Contents
- Table of contents
- I. Getting Started
- II. Hardware description
- III. Installation procedure
- 1. Installation preparations
- 2. InfiNet Wireless R5000-Omx/Omxb
- 3. InfiNet Wireless R5000-Lmn
- 4. InfiNet Wireless R5000-M/Mm and R5000-Smn/Smnb/Smnc
- 5. Mounting kit (MOUNT-KIT-85)
- 8. InfiNet Wireless R5000-Smnc
- II. Configuration (Web-interface)
- III. Configuration (CLI)
- IV. Link setup
- V. Lost password recovery
- VI. Recommendations
- VII. Supplementary information
64
Copyright © 2004-2012 by InfiNet Wireless
This section allows user to create a local nodes database. Please refer to the
Nodes Authentication and Creating local nodes database sections
of the
Mint
chapter of the WANFleX OS User Manual for more information.
Available settings are:
• MAC – defines the MAC-address of the allowed node.
• Disabled – this checkbox temporarily disables the corresponding record in
the database.
• Key – a unique key configured on the neighbor unit, can be up to 64
characters long, must not contain spaces. Refer to the Security Key
paragraph in the previous section.
• Note – used to provide a short description.
• Remove – this button permanently removes the corresponding node from
the database.
MAC Switch
This section allows users to configure the switch operation including switch
group management.
General section:
• Help – displays general help guidelines for MAC switch configuration.
• Enable Switch – this checkbox enables/disables global switch operation.
• Management VLAN – sets the VLAN ID for management traffic. When set,
device access and configuration are possible only via the specified
Management VLAN.
• Create Switch Group – creates a new switch group.
Switch Group configuration section:
• Group# – assigns the switch group identifier (must be unique within the
MINT network segment).
• Enabled – enables/disables the corresponding switching group.
• Add Interface– allows including local network interfaces (ethX, rfX, tunX,
etc.) into the switch group.