Quick Start Manual

Table Of Contents

InfiNet Wireless Router Quick start guide

Once the power is switched on, you can access the router via Telnet (all

necessary configuration steps were already taken in the lab).

It takes approximately 10-15 seconds for RMA to perform registration procedure.

After this period of time you can check the following:

• On BS: type “rma ab” to learn whether CPEs are registered

• On CPE: type “rma bs” to learn whether CPE has a BS registration

If it turns out that during some significant period of time (1 minute) there is no

CPE registration at BS, it can generally imply two options:

• Link fade margin is not sufficient to handle the connection

• Antenna alignment procedure is required in order to establish the connection

Even if registration has occurred but signal levels are not enough (signal levels

according to InfiNet scale are meant in the case, antenna alignment procedure is

strongly recommended.

In both cases (whether there is a registration or not) the following procedure for

antenna alignment is recommended:

1. Either on BS device or CPE run rma test. Run it only from ONE side. The

command looks as follows:

rma rf4.0 test <MAC> 1400

Here, <MAC> - is a MAC-address of the CPE radio.

1400 – the length of the testing packet.

From CPE side it is possible to run rma test only if CPE has a registration on

BS.

2. Antenna alignment should be done only from one side at one time. Align one

side, than other side. Use mobile phones to check current signal levels. The

output of rma test command is demonstrated on the Figure 32.

Figure 32. Rma test output

3. The link can be claimed to be working when the following requirements are

met:

• Percentage of LostIn and LostOut packets is equal to 0

• Quality parameter is 120 and higher

• No repeats (00/00/00 value must be obtained)