Quick Start Manual

Table Of Contents

InfiNet Wireless Router Quick start guide

• Achievement of required signal levels (In and Out parameters).

Appropriate signal levels are from 4(5) to 10(11). Keep in mind that

the antenna alignment should be performed slowly and with pauses.

After each alignment step it is required to wait for at least 3 seconds

to see the alignment result in rma test table.

4. Interference can be a possible reason for the link quality degradation

(number of repeats increases, CPE does not register at the BS etc). Muffer

utility is used to monitor electromagnetic environment. In order to run

muffer one should turn RMA off using rma stop command. Review mode is

recommended to see the activity on all available for your radio frequencies:

muffer rf4.0 review

Figure 33 shows a sample output for this command.

Figure 33. Muffer review mode

On the figure we can see the activity on frequencies 5260 and 5300 MHz. If a

strong and permanent activity is located on the frequency that is used by your

link, it is strongly recommended to switch to another frequency which is free

from any activity.

5. If you fail to establish a link on a desired bitrate you can either change the

requested speed from CPE or turn on autobitrate mechanism. This mechanism

automatically varies the speed (from both sides) according to changing link

conditions. If the mechanism is turned on on CPE, the BS will also work with this

mechanism. If it is turned on on BS, the whole cell will switch to this mode. The

syntax for the command is the following:

rma rf4.0 autobitrate