User's Manual
Table Of Contents
- Table of contents
- FCC Regulatory Notice
- Industry Canada Regulatory Notice
- Antenna installation and operation information
- I. Getting Started
- II.Hardware description
- III.Installation procedure
- IV. Device configuration instructions
- V. Link Configuring
- VI. Services, features and tools
- VII.GUI “InfiNet Wireless Router Manager”
- VIII.Recommendations
- IX. Supplementary information
InfiNet Wireless R5000 Technical User Manual
Copyright © 2004-2006 by InfiNet Wireless Limited.
21
9. Isolate the ODU connector joint place
10. Once the ODU and antenna pole are installed they must be grounded via
lightning protection grounding contour. ODU position must be lower than the
highest antenna pole point at least by 2 ODU heights
11. Connect the UTP cable to IDU
12. Provide grounding for IDU
13. Connect Ethernet cable to IDU
14. Provide power supply for IDU
15. Connect to the Router using
Telnet protocol
It is extremely important to install ODU connectors down!
Wall mounting kit assembling
Attention! By default, the mounting kit for R5000-S does NOT contain a
plate for wall mounting – it should be ordered separately.