User's Manual
Table Of Contents
- Table of contents
- FCC Regulatory Notice
- Industry Canada Regulatory Notice
- Antenna installation and operation information
- I. Getting Started
- II.Hardware description
- III.Installation procedure
- IV. Device configuration instructions
- V. Link Configuring
- VI. Services, features and tools
- VII.GUI “InfiNet Wireless Router Manager”
- VIII.Recommendations
- IX. Supplementary information
InfiNet Wireless R5000 Technical User Manual
Copyright © 2004-2006 by InfiNet Wireless Limited.
33
Link Test & Control
A Base Station performs a permanent link testing with a subscriber. Each testing
is accompanied by subscriber’s information update in the Base Station’s tables.
This mechanism provides a system operator with comprehensive data concerning
registered subscribers and links quality without any additional tests launching.
RMA usage
The following procedure is recommended for RMA protocol configuration:
• Define which of the network components act as a BS and which are CPEs
• Configure all CPEs on the BS using “rma ab” command
• Configure BS on each CPE using “rma bs” command
• Run RMA on each device using “rma start” command. RMA mode can
be disabled using “rma stop” command
• Enable polling mode on the BS
• Define which links are not stable at the configured speeds and try using
autobitrate mode either for some specific CPEs or for the whole cell