Kiosk thermal printer User Manual KPM-210, 216

3. PRINTER FUNCTIONS

KPM210/216

183-

for the 300 dpi model :

medoM

noitceridlacitreVnoitceridlatnoziroH

stod.NIPDIPD)k(ataDfo.N

elgnistod8

ytisned

8001051652xHn+Ln

elbuodtod8

ytisned

8001003652xHn+Ln

elgnistod42

ytisned

420030513x)652xHn+Ln(

elbuodtod42

ytisned

420030033x)652xHn+Ln(

[Notes] • The nL and nH commands indicate the number of dots of

the bit image in the horizontal direction. The number of dots

is calculated using: nL + nH × 256.

• If the bit image data input exceeds the number of dots to be

printed on a line, the excess data is ignored.

• d indicates the bit image data. Set a corresponding bit to 1

to print a dot, or to 0 to not print the dot.

• If the value of m is outside the specified range, nL and data

following it are processed as normal data.

• If the width of the printing area set by GS L and GS W is

less than the width required by the data set using ESC * , the

excess data are ignored.

• To print the bit image use LF, CR, ESC J or ESC d.

• After printing a bit image, the printer returns to normal data

processing mode.

• This command is not affected by the emphasized, double-

strike, underline (etc.) print modes, except for the upside-

down mode.

• The relationship between the image data and the dots to be

printed is as follows:

(Tab.A.3)