- Infinite Alarming & remote control unit User Guide SCOM-100

SCOM-100, User guide 34
1700,1,0,8:00-120,11:30-100;16:45-180
A schedule program can be attached the device’s outputs
by using the following command:
1030,m,n,ID
1030: Command ID
m: Module number (0 for SCOM-100 main
unit, 1-8 for DI-42 I/O expansion units)
n: Output number (1-4 for SCOM-100
main unit, 1-2 for DI-42 I/O expansion
units)
ID: Time schedule ID (1-10)
A device output attached on a schedule ID will operate
according to the following rules:
1. On each day the specific daily schedule program
with the respective ID is followed.
2. If no specific day (e.g. for Tuesday) program with the
respective ID exists, the ‘Everyday’ program is
followed.
3. If no specific day program and also no ‘Everyday’
program with the respective ID exist, the output
remains off for the whole day.
4. The output is activated at the next
switch on time
stamp.
The ‘Clear DO configuration’ command can be used to
remove the time schedule configuration of an output (see
4.4.8).
A special command is available for controlling the total
ON time duration in a day program:
1701,ID,P