Owner's Manual

button. During programming, your hand-
held transmitter may automatically stop
transmitting. Continue to press and hold
the desired HomeLink
®
button while you
press and re-press (“cycle”) your hand-
held transmitter every two seconds until
the frequency signal has been learned. The
HomeLink
®
indicator light will flash slowly
and then rapidly after several seconds
upon successful programming. DO NOT
release until the HomeLink
®
indicator light
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. The rapid flashing
indicates successful programming.
Proceed with “Programming HomeLink
®
”
step 3 to complete.
Remember to plug the device back in when
programming is completed.
OPERATING THE HomeLink
®
UNI-
VERSAL TRANSCEIVER
The HomeLink
®
Universal Transceiver, after
it is programmed, can be used to activate
the programmed device. To operate, simply
press and release the appropriate pro-
grammed HomeLink
®
Universal Transceiver
button. The amber indicator light will
illuminate while the signal is being trans-
mitted.
For convenience, the hand-held transmitter
of the device may also be used at any time.
PROGRAMMING TROUBLESHOOT-
ING
If the HomeLink
®
does not quickly learn
the hand-held transmitter information:
. replace the hand-held transmitter bat-
teries with new batteries.
. position the hand-held transmitter with
its battery area facing away from the
HomeLink
®
surface.
. press and hold both the HomeLink
®
and hand-held transmitter buttons
without interruption.
. position the hand-held transmitter 1-3
in (26-76 mm) away from the
HomeLink
®
surface. Hold the transmit-
ter in that position for up to 15
seconds. If HomeLink
®
is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at all
times.
If you have any questions or are having
difficulty programming your HomeLink
®
buttons, refer to the HomeLink
®
web site
at: www.homelink.com or 1-800-355-3515.
CLEARING THE PROGRAMMED IN-
FORMATION
The following procedure clears the pro-
grammed information from both buttons.
Individual buttons cannot be cleared.
However, individual buttons can be repro-
grammed, see “Reprogramming a single
HomeLink
®
button” later in this section.
To clear all programming
1. Press and hold the two outer
HomeLink
®
buttons until the indicator
light begins to flash in approximately
10 seconds. Do not hold for longer than
20 seconds.
2. Release both buttons.
HomeLink
®
is now in the programming
mode and can be programmed at any time
beginning with “Programming HomeLink
®
”
- Step 1.
REPROGRAMMING A SINGLE
HomeLink
®
BUTTON
To reprogram a HomeLink
®
Universal
Transceiver button, complete the following.
1. Press and hold the desired HomeLink
®
button. Do not release the button.
Instruments and controls 2-71