Owner's Manual

5-44 Starting and driving
SSD1040
NOTE:
. The Blind Spot Intervention
TM
system
will not operate if your vehicle is on a
lane marker when another vehicle
enters the detection zone. In this case
only the BSW system operates.
. Blind Spot Intervention
TM
braking will
not operate or will stop operating and
only a warning chime will sound under
the following conditions.
— When the brake pedal is depressed.
— When the accelerator pedal is de-
pressed while brake control assist
is provided.
— When steering quickly
— When the ICC, DCA, FCW or IBA
warnings sound.
— When the hazard warning flashers
are operated.
— When driving on a curve at a high
speed.
BSW/Blind Spot Intervention
TM
temporarily not available
. Under the following conditions, the
Blind Spot Intervention
TM
system will
be turned off automatically, a beep will
sound and the Blind Spot Interven-
tion
TM
ON indicator light (green) will
blink. The BSW system is still available,
but the Blind Spot Intervention
TM
sys-
tem will not be available until the
conditions no longer exist.
— When the VDC system (except TCS
function) or ABS operates.
— When the VDC system is turned off.
— When the drive mode select switch
is turned to the SNOW mode.
Action to take:
Turn off the Blind Spot Intervention
TM
system and turn it on again when the
above conditions no longer exist.
. Under the following conditions, the
BSW and Blind Spot Intervention
TM
systems will be turned off automati-
cally, a beep will sound and the BSW/
Blind Spot Intervention
TM
system warn-
ing light (orange) will blink. The BSW
and Blind Spot Intervention
TM
systems
are not available until the conditions no
longer exist.
— When the camera detects that the
interior temperature is high (over
approximately 1048F (408C)).
— When radar blockage is detected.
The radar sensors may be blocked by
temporary ambient conditions such as
splashing water, mist or fog. The blocked
condition may also be caused by objects
such as ice, frost or dirt obstructing the
radar sensors.
Action to take:
When the above conditions no longer exist,
the BSW system will resume automatically.
For the Blind Spot Intervention
TM
system,
turn it off and turn it on again. If the BSW/
Blind Spot Intervention
TM
warning light
(orange) continues to blink even after the
Blind Spot Intervention
TM
system is turned
on again, stop the vehicle in a safe location
and turn the engine off. Check for and