Operation Manual

1. To begin, push and hold the 2 outer
HomeLink姞 buttons (to clear the memory)
until the indicator light
䊊
A
blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held trans-
mitter 1-3 inches away from the
HomeLink姞 surface.
3. Using both hands, simultaneously push
and hold both the HomeLink姞 button you
want to program and the hand-held trans-
mitter button.
DO NOT release the buttons until step 4
has been completed.
4. Hold down both buttons until the indica-
tor light on HomeLink姞 flashes, changing
from a “slow blink” to a “rapid blink”.
This could take up to 90 seconds. When
the indicator light blinks rapidly, both
buttons may be released. The rapidly
flashing light indicates successful pro-
gramming. To activate the garage door or
other programmed device, push and hold
the programmed HomeLink姞 button - re-
leasing when the device begins to acti-
vate.
5. If the indicator light on HomeLink姞 blinks
rapidly for two seconds and then turns
solid, HomeLink姞 has picked up a “rolling
code” garage door opener signal. You will
need to proceed with the next steps to
train HomeLink姞, completing the pro-
gramming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s mo-
tor to activate the “training mode”. This
button is usually located near the an-
tenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the
lens to access the training button.
SIC3182 SIC3183
2-58 Instruments and controls