Operation Manual

Manual folding
Pull the lever
䊊
A
located on the right side or left
side of the seatback before folding down the
corresponding seatback.
Part of the release lever is marked with a red
indicator. The red indicator is visible if the
seatback is not fully latched.
Return the rear seatback manually until it se-
curely locks in position. Make sure the red
indicator on the release lever is not visible
when the seats are in the upright and latched
position.
HEAD RESTRAINTS
WARNING
Head restraints supplement the other vehicle
safety systems. They may provide additional
protection against injury in certain rear end
collisions. Adjust the head restraints properly,
as specified in this section. Check the adjust-
ment after someone else uses the seat. Do not
attach anything to the head restraint stalks or
remove the head restraint. Do not use the seat
if the head restraint has been removed. If the
head restraint was removed, reinstall and prop-
erly adjust the head restraint before an occu-
pant uses the seating position. Failure to follow
these instructions can reduce the effectiveness
of the head restraints. This may increase the
risk of serious injury or death in a collision.
The illustration shows the seating positions
equipped with head restraints. The head re-
straints are adjustable.
Indicates the seating position is
equipped with a head restraint.
SSS0830 SSS1013
1-6 Safety — Seats, seat belts and supplemental restraint system