Operation Manual

NOTE:
If the extended storage switch malfunctions, or
if the fuse is open, it is not necessary to replace
the switch. In this case, remove the extended
storage switch and replace it with a new fuse of
the same rating.
How to remove the extended storage switch:
1. To remove the extended storage switch,
be sure the ignition switch is in the “OFF”
or “LOCK” position.
2. Be sure the headlight switch is in the
“OFF” position.
3. Remove the fuse box cover.
4. Pinch the locking tabs
䊊
1
found on each
side of the storage switch.
5. Pull the storage switch straight out from
the fuse box
䊊
2
.
Replace the battery as follows:
1. Release the lock knob at the back of the
Intelligent Key and remove the mechanical
key.
2. Insert a flat-blade screwdriver
䊊
A
wrapped with a cloth into the slit
䊊
B
of
the corner and twist it to separate the
upper part from the lower part.
3. Replace the battery with a new one.
Recommended battery: CR2032 or equiva-
lent.
● Do not touch the internal circuit and electric
terminals as it could cause a malfunction.
● Hold the battery by the edges. Holding the
battery across the contact points will seri-
ously deplete the storage capacity.
● Make sure that the + side faces the bottom
of the case.
4. Align the tips of the upper and lower
parts, and then push them together until
it is securely closed.
5. Push the buttons two or three times to
check its operation.
SPA1875 SDI2285
INTELLIGENT KEY BATTERY REPLACEMENT
8-22 Maintenance and do-it-yourself