Operation Manual

3. Choose the right or left outside mirror
by operating the outside mirror control
switch.
4. The selected outside mirror surface
moves downward.
5. When one of the following conditions
has occurred, the selected outside
mirror surface will return to its original
position.
O The selector lever is moved to any po-
sition other than R (Reverse).
O The outside mirror control switch is
set to the center position.
O The ignition switch is pushed to the
LOCK position.
For more information regarding this fea-
ture and how to save the R (Reverse) mir-
ror tilt-down adjustment in the “Automatic
drive positioner” memory, refer to “Auto-
matic drive positioner” later in this sec-
tion.
The automatic drive positioner system
has two features:
O Entry/exit function
O Memory storage
ENTRY/EXIT FUNCTION
This system is designed so that the driv-
er’s seat and steering column will auto-
matically move when the automatic trans-
mission selector lever is in the P (Park)
position. This allows the driver to get into
and out of the driver’s seat more easily.
The driver’s seat will slide backward and
the steering wheel will move up when the
driver’s door is opened with the ignition
switch in the LOCK position.
The driver’s seat and steering wheel will
return to the previous positions when one
of the following is operated:
O When the ignition switch is pushed to
the ACC position after the driver’s
door is closed.
O When the ignition switch is pushed to
the ON position.
Cancel or activate entry/exit
function
The entry/exit function can be activated
or cancelled by pressing and holding the
SET switch for more than 10 seconds
while the ignition switch is in the LOCK
position.
The indicator light will blink once when
the function is cancelled, and the indi-
cator light will blink twice when the func-
tion is activated.
The entry/exit function can also be acti-
vated or cancelled from the setting dis-
play. See “Vehicle information and set-
tings” in the “4. Monitor, climate, audio,
phone and voice recognition systems”
section.
Initialize entry/exit function
If the battery cable is disconnected, or if
the fuse opens, the entry/exit function
will not work though this function was set
on before. In such a case, after con-
necting the battery or replacing with a
new fuse, open and close the driver’s
door more than two times after the igni-
tion switch is pushed to the ON position
once, then pushed to the LOCK position.
The entry/exit function will be activated.
AUTOMATIC DRIVE POSITIONER
Pre-driving checks and adjustments 3-25
w 06.3.30/Y50-D X