Operation Manual

MEMORY STORAGE
Two positions for the driver’s seat,
steering column and outside mirrors can
be stored in the automatic drive posi-
tioner memory. Follow these procedures
to use the memory system.
1. Set the selector lever to the P (Park)
position.
2. Push the ignition switch to the ON po-
sition.
3. Adjust the driver’s seat, steering
column and outside mirrors to the de-
sired positions by manually operating
each adjusting switch. For additional
information, see “Seats” in the
“1. Safety — Seats, seat belts and
supplemental restraint system” sec-
tion and “Tilting telescopic steering
column” and “Outside mirrors” earlier
in this section.
4. Push the SET switch and, within 5 sec-
onds, push the memory switch (1 or 2)
fully for at least 1 second.
The indicator light for the pushed
memory switch will come on and stay
on for approximately 5 seconds after
pushing the switch. After the indicator
light goes off, the selected positions
are stored in the selected memory (1
or 2).
If memory is stored in the same
memory switch, the previous memory
will be deleted.
Procedure for storing the outside
mirror positions for best visibility
at reverse tilt-down feature
Two outside mirror positions for backing
up can be stored in the automatic drive
positioner memory.
1. Apply the parking brake.
2. Push the ignition switch to the ON po-
sition. (Do not start the engine.)
3. Push the memory switch 1 or 2 fully
for at least 1 second to operate the au-
tomatic drive positioner.
4. Turn the outside mirror control switch
to L (left).
5. Depress the brake pedal.
6. Move the automatic transmission se-
lector lever to R (Reverse).
7. Adjust the mirror to the desired
viewing position for backing up by op-
erating the outside mirror control
switch.
8. Push the SET switch and, within 5 sec-
onds, push the memory switch 1 or 2
selected in step 3 fully for at least 1
second.
O The indicator light for the pushed
memory switch will come on and stay
on for approximately 5 seconds after
pushing the switch. After the indicator
light goes off, the selected mirror po-
sition is stored in the selected
memory (1 or 2).
9. Turn the outside mirror control switch
to R (right).
SPA2020
3-26 Pre-driving checks and adjustments
w 06.3.30/Y50-D X