Operation Manual

Heating (A/C OFF)
The air conditioner does not activate in
this mode. When you need to heat only,
use this mode.
1. Push the “A/C” button. (The A/C indi-
cator will turn off.)
2. Push the temperature control button
to set the desired temperature.
O The temperature of the passenger
compartment will be maintained auto-
matically. Air flow distribution and fan
speed are also controlled automati-
cally.
O Do not set the temperature lower than
the outside air temperature. Otherwise
the system may not work properly.
O Not recommended if windows fog up.
Dehumidified defrosting or
defogging
1. Push the “ ” front defroster
button. (The indicator light on the but-
ton will come on.)
2. Push the temperature control button
to set the desired temperature.
O To quickly remove ice from the outside
of the windows, push the fan speed
increase button “
+” and set it to
the maximum position.
O As soon as possible after the wind-
shield is clean, push the “AUTO”
button to return to the auto mode.
O When the “
” front defroster
button is pushed, the air conditioner
will automatically be turned on at out-
side temperatures above 23°F (−5°C)
to defog the windshield, and the air
recirculate mode will automatically be
turned off.
Outside air is drawn into the pas-
senger compartment to improve the
defogging performance.
MANUAL OPERATION
Fan speed control
Push the fan speed increase “ +” or
decrease “
2” buttons to manually
control the fan speed.
Push the “AUTO” button to return to auto-
matic control of the fan speed.
Air recirculation
Push the intake air control button
“
” to recirculate interior air in-
side the vehicle. The indicator light on the
“
” side will come on.
The air recirculation mode cannot be
activated when the air conditioner is in the
front defrosting mode “
”.
Outside air circulation
Push the intake air control button
“
” to draw outside air into the
passenger compartment. The indicator
light on the “
” side will come on.
Automatic intake air control
In the AUTO mode, the intake air will be
controlled automatically. To manually con-
trol the intake air, push the intake air
control button “
”. To return to
the automatic control mode, push the in-
take air control button “
” for
about 2 seconds. The indicator lights
(both air recirculation and outside air cir-
culation sides) will flash twice, and then
the intake air will be controlled automati-
cally.
Air flow control
Pushing the “MODE” manual air flow con-
trol button selects the air outlet to:
4-26 Monitor, climate, audio, phone and voice recognition systems
w 06.12.14/Y50-D X