Operation Manual

pressure warning light OFF. If the light
still comes on while driving after ad-
justing the tire pressure, a tire may be
flat. If you have a flat tire, replace it with
a spare tire as soon as possible. (See
“Flat tire” in the “6. In case of emer-
gency” section for changing a flat tire.)
O Immediately after tire rotation is per-
formed, tire pressure will not be indi-
cated on the display and the TPMS will
not function. Reset the system by driving
the vehicle at over 25 MPH (40 km/h) for
approximately 10 minutes. If tire pres-
sure is not indicated after performing the
resetting procedure above, contact an
INFINITI dealer as soon as possible.
O When a spare tire is mounted or a wheel
is replaced, tire pressure will not be indi-
cated, the TPMS will not function and the
low tire pressure warning light will flash.
Contact your INFINITI dealer as soon as
possible for tire replacement and/or sys-
tem resetting.
O Replacing tires with those not originally
specified by INFINITI could affect the
proper operation of the TPMS.
O
Do not inject any tire liquid or aerosol tire
sealant into the tires, as this may cause a
malfunction of the tire pressure sensors.
CAUTION
O The low tire pressure warning system
may not function properly when the
wheels are equipped with tire chains or
the wheels are buried in snow.
O Do not place metalized film or any metal
parts (antenna, etc.) on the windows.
This may cause poor reception of the sig-
nals from the tire pressure sensors, and
the TPMS will not function properly.
O Some devices and transmitters may tem-
porarily interfere with the operation of
the TPMS and cause the low tire pres-
sure warning light to illuminate. Some
examples are:
— Facilities or electric devices using
similar radio frequencies are near the
vehicle.
— If a transmitter set to similar frequen-
cies is being used in or near the ve-
hicle.
— If a computer (or similar equipment)
or a DC/AC converter is being used in
or near the vehicle.
FCC Notice:
Changes or modifications not expressly
approved by the party responsible for com-
pliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules and RSS-210 of Industry Canada.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received, in-
cluding interference that may cause un-
desired operation of the device.
Starting and driving 5-5
w 06.12.15/Y50-D X