Operation Manual

PRE-CRASH SEAT BELTS (front
seats) (if so equipped)
The pre-crash seat belt tightens the seat
belt to help restrain front seat occupants
under emergency braking. This can help
reduce the risk of injury when a collision
occurs.
Pre-crash seat belts will not be activated
when:
O the brake pedal is not depressed
O the seat belt is not fastened
O the selector lever is in the reverse po-
sition
O the vehicle speed is under 10 MPH (15
km/h)
Always wear your seat belt correctly and
sit upright and well back.
If the seat belt warning light blinks even if
the driver’s and front passenger’s seat
belts are fastened, it may indicate the
pre-crash seat belt system has a malfunc-
tion. Have your INFINITI dealer check and
repair the system.
THREE-POINT TYPE SEAT BELT
WARNING
O Every person who drives or rides in this
vehicle should use a seat belt at all
times.
O Do not ride in a moving vehicle when the
seatback is reclined. This can be dan-
gerous. The shoulder belt will not be
against your body. In an accident, you
could be thrown into it and receive neck
or other serious injuries. You could also
slide under the lap belt and receive seri-
ous internal injuries.
O For the most effective protection when
the vehicle is in motion, the seat should
be upright. Always sit well back in the
seat with both feet on the floor and ad-
just the seat belt properly.
Fastening the seat belts
1. Adjust the seat. See “Seats” earlier in
this section.
2. Slowly pull the seat belt out of the re-
tractor and insert the tongue into the
buckle until it clicks.
O The retractor is designed to lock during
a sudden stop or on impact. A slow
pulling motion will permit the belt to
move, and allow you some freedom of
movement in the seat.
O If the seat belt cannot be pulled from
its fully retracted position, firmly pull
SSS0292
Front seat
1-12 Safety — Seats, seat belts and supplemental restraint system
w 06.3.30/Y50-D X