Operation Manual

REPLACING
Replace the wiper blades if they are worn.
1. Push the ignition switch to the ON po-
sition and the windshield wiper switch
ON. Push the ignition switch to the
LOCK position when the wiper is in the
fully up position. The wiper will stop
as illustrated.
The wiper should be in the fully up position
to avoid scratching the engine hood or
wiper arm.
2. Pull the wiper arm.
3. Push the release tab
q
A
, and then
move the wiper blade down the wiper
arm
q
1
while pushing the release tab
to remove.
4. Insert the new wiper blade onto the
wiper arm until a click sounds.
CAUTION
O After wiper blade replacement, return
the wiper arm to its original position;
otherwise it may be damaged when the
hood is opened.
O Make sure the wiper blades contact the
glass; otherwise the arm may be dam-
aged from wind pressure.
O Worn windshield wiper blades can
damage the windshield and impair
driver vision.
SDI1874
SDI1649
8-24 Maintenance and do-it-yourself
w 06.3.30/Y50-D X