Operation Manual

Use the following steps to mount the li-
cense plate:
Before mounting the license plate, con-
firm that the following parts are enclosed
in the plastic bag.
Only use the recommended mounting po-
sition or Intelligent Cruise Control (ICC)
sensor obstruction (if so equipped) may
result.
O License plate bracket
O J-nut x 2
O Screw x 2
O Screw grommet x 2
1. Temporarily place the license plate
bracket while aligning part
q
A
of the
front bumper with part
q
B
of the rear
surface of the license plate bracket.
2. To determine where to drill the hole,
mark along both sides of the
mounting hole by using a felt-tip pen.
3. Remove the license plate bracket and
connect the arcs to form ovals. Mark
the point in the center of each oval.
These are the pilot drilling locations.
4. Carefully drill two pilot holes using a
0.39 in (10 mm) drill bit at the marked
STI0419
INSTALLING FRONT LICENSE PLATE
9-12 Technical and consumer information
w 06.12.8/Y50-D X