Operation Manual

7. Before placing the child in the child
restraint, hold child restraint near the
LATCH attachment and use force to
push the child restraint from side to
side, and tug it forward to make sure
that it is securely held in place. It
should not move more than 1 in (25
mm). If it does move more than 1 in
(25 mm), pull again on the anchor at-
tachments to further tighten the child
restraint. If you are unable to properly
secure the restraint, move the re-
straint to another seating position and
try again, or try a different child re-
straint. Not all child restraints fit in all
types of vehicles.
8. Check to make sure the child restraint
is properly secured prior to each use.
If the child restraint is loose, repeat
steps 4 through 7.
Rear-facing
Follow these steps to install a rear-facing
child restraint using LATCH:
1. If your vehicle is equipped with rear
power seat adjustment, adjust the rear
outboard seats to the uplight and re-
armost position.
O Do not move the rear outboard seats
with the child restraints attached to
them.
2. Position the child restraint on the
seat. Always follow the child restraint
manufacturer’s instructions.
SSS0638
Front facing − step 7
SSS0648
Rear facing − step 3
Safety — Seats, seat belts and supplemental restraint system 1-23
w 06.3.30/Y50-D X