Operation Manual

switch to the OFF, ,or position.
The autolight system can turn on the
headlights automatically when it is dark
and turn off the headlights when it is
light.
If the ignition switch is pushed to the
LOCK position and one of the doors is
opened and this condition is continued,
the headlights remain on for 5 minutes.
Automatic headlights off delay
You can keep the headlights on for up to
180 seconds after you push the ignition
switch to LOCK and open any door then
close all the doors.
You can adjust the period of the auto-
matic headlights off delay from 0 seconds
(OFF) to 180 seconds.
For automatic headlights off delay setting,
see “Automatic headlights off delay” in
the “4. Monitor, climate, audio, phone
and voice recognition systems” section.
Be sure not to put anything on top of the
photo sensor
q
A
located on the top of the
instrument panel. The photo sensor con-
trols the autolight; if it is covered, the
photo sensor reacts as if it is dark and the
headlights will illuminate.
Headlight beam select
q
1
To select the low beam, put the lever
in the neutral position as shown.
q
2
To select the high beam, push the
lever forward while the switch is in the
position. Pull it back to select
the low beam.
q
3
Pulling the lever toward you will flash
the headlight high beam even when
the headlight switch is in the OFF po-
sition.
SAA0642A SIC2413
2-28 Instruments and controls
w 06.3.30/Y50-D X