Overture 2/3 Ins 9/11/98 4:23 PM Page 14 ® Models OVTR 2, OVTR 3 3-Way Full-Range Floorstanding Speakers Owner’s Manual OVTR 2 Part #331250 – USA 120 Vac Only OVTR 3 Part #331251 – USA 120 Vac Only
Overture 2/3 Ins 9/11/98 4:23 PM Page 20 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
Overture 2/3 Ins 9/11/98 4:23 PM Page 1 INTRODUCTION 3-WAY FLOOR-STANDING SPEAKERS WITH INTEGRATED POWERED SUBWOOFERS... Infinity Compositions Overture OVTR 2 and OVTR 3 speaker systems are a pair of advanced, 3-way full-range, floor-standing speakers with integrated powered subwoofers. Housed in slender columns, these highly-efficient speakers require only minimal power to produce sound levels greater than those heard in a movie theater.
Overture 2/3 Ins 9/11/98 4:23 PM Page 2 INSTALLING THE FEET Compositions Overture OVTR 2 and OVTR 3 speakers use dual-purpose feet with spike and round ends for carpeted or hard-surface floors. Refer to Figures 1 and 2 as you perform the following steps: 1. Lay each speaker on its side and locate the four threaded holes on the bottom (see Figure 1). Foot Hole USE E F Foot Hole US Figure 1.
Overture 2/3 Ins 9/11/98 4:23 PM Page 3 Figure 2. This cross-section shows how to install a foot onto the bottom of a Compositions Overture OVTR 2 or OVTR 3 speaker. Bottom Of Speaker Locking Nut 5 ⁄ 8" min. 5 ⁄ 8" Foot 11 ⁄ 8" max. round end spike end Nylon Dome (optional for wood floors) CARPETED FLOORS HARD-SURFACE FLOORS 2. For carpets, screw the round end of a foot into each hole and handtighten a nut onto each one (see Figure 2).
Overture 2/3 Ins 9/11/98 4:23 PM Page 4 PLANNING YOUR SYSTEM STEREO PLACEMENT... Before deciding where to put your Compositions Overture speakers, survey your room and think about placement, keeping the following points in mind: ◆ For best results, try placing the speakers closer together than the distance to the listening area. ◆ Refer to Figure 3 when placing speakers for best bass level and stereo image (also see Operating The System on page 6). Figure 3.
Overture 2/3 Ins 9/11/98 4:23 PM Page 5 WIRING THE SYSTEM TURN OFF ALL POWER... IMPORTANT! After placing the speakers, you are ready to connect your system. First turn off all audio system power. Use high-quality speaker wire to make your connections. For speaker connections, use #18 gauge speaker wire (or #16 for runs over 25 feet) with polarity coding. The side of the wire with a ridge or other coding is usually considered negative polarity (i.e., – ).
Overture 2/3 Ins 9/11/98 4:23 PM Page 6 Figure 5. Wiring diagram shows polarity connections for one channel of a stereo or home theater system. OVTR 2 OVTR 3 (rear view) Receiver or Amplifier (rear view) blk – + red + – (one channel shown) OPERATING THE SYSTEM Each Compositions Overture OVTR 2 or OVTR 3 speaker system contains a built-in power amplifier that drives the subwoofers and only requires connection of the ac power cord.
Overture 2/3 Ins 9/11/98 4:23 PM Page 7 OPERATING THE SYSTEM (CONT ’ D) POWER ON... CHECKING PLAYBACK... 1. After speaker wiring has been completed, connect each speaker’s ac power cord to the nearest ac receptacle. You should see an LED illuminate, indicating the amplifier is on (see Figure 6 on previous page). If not, verify the ac outlet is delivering power or refer to Troubleshooting on the next page. 2.
Overture 2/3 Ins 9/11/98 4:23 PM Page 8 CARE OF YOUR SPEAKER SYSTEM The black-ash or cherry wood finish does not require any routine maintenance. When needed, use a soft cloth, dampened with water only, to remove any fingerprints or to wipe off dust. Clean the grille by gentle vacuuming or with a damp cloth. NOTE: Do not use any cleaning products or polishes on the cabinet or grille.
Overture 2/3 Ins 9/11/98 4:23 PM Page 9 SPECIFICATIONS – OVTR 2 PERFORMANCE DATA Frequency Range: 30 ~ 20,000 Hz Sensitivity: 93 dB @ 2.
Overture 2/3 Ins 9/11/98 4:23 PM Page 10 SPECIFICATIONS – OVTR 3 PERFORMANCE DATA Frequency Range: 25 ~ 20,000 Hz Sensitivity: 94 dB @ 2.
Overture 2/3 Ins 9/11/98 4:23 PM Page 11 Figure 7. Overall dimensions of the Compositions Overture OVTR 3 and OVTR 2 speakers.
Overture 2/3 Ins 9/11/98 4:23 PM Page 12 LIMITED FIVE-YEAR WARRANTY Who is protected by the warranty? Your Infinity warranty protects the original retail purchaser and all subsequent owners for a period of five (5) years (parts and labor) for all speaker components, and one (1) year (parts and labor) for all electronics, from any failure as a result of an original manufacturing defect so long as: (1) your Infinity loudspeakers were purchased within the fifty states of the U.S.A.
Overture 2/3 Ins 9/11/98 4:23 PM Page 13 ® Infinity Systems, Inc.