User manual

Ordercode: 41551

Infinity iFX-615

Control Modes

There are 3 modes:

• Stand-alone

• Master/Slave

• DMX-512 (25CH, 49CH)

One Infinity (Stand-alone)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.

02) Always use a safety cable (ordercode 70140 / 70141).

03) Plug the end of the electric mains power cord into a proper electric power supply socket.

04) When the Infinity is not connected with a DMX cable, it functions as a stand-alone device.

Please see pages 14-19 for more information about the Stand-alone mode.

Multiple Infinitys (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

02) Always use a safety cable (ordercode 70140 / 70141).

03) Use a 3-pin XLR cable to connect the Infinity.

The pins:

01) Earth

02) Signal -

03) Signal +

04) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"

socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.

You can use the same functions on the master device as described on pages 14-19. This means that

you can set your desired operation mode on the master device and all slave devices will react the

same as the master device.

Multiple Infinitys (Master/Slave control)

Fig. 03