INSTALLATION BULLETIN To avoid possible water ingress into wire harness area, route the harness in the downward direction as shown below on the left. Do not route the harness in the upward direction as shown on the right.
~ lnflniW, 1 •.
Product Description This radio features state of the art Bluetooth technology allowing music to wirelessly stream from an audio source to the receiver you just purchased. Why Bluetooth? From a practical standpoint, Bluetooth enables your music device (if applicable) to be placed in a glove box, your overhead console, or even your pocket-places that are dry-without having to install a separate docking station.
Front Panel Lay out Power On/Off button. Short push for the first time to turn the unit on. Press and hold for more than 2 seconds to turn the unit off. MODE Mode Function. Switches amongst Radio, Bluetooth, USB and Auxiliary mode. SEL SEL stands for SELECT. BAND Band Function. Switches amongst AM and FM bands. A.PS Auto Preset and Presets Scan. Preset I while in Radio mode; Play/Pause while in USB and BT Music mode.
Front Panel Layout 2 INT Preset 2 while in Radio mode; Introduction while in USB mode. 3RPT Preset 3 while in Radio mode; Repeat while in USB mode. 4RDM Preset 4 while in Radio mode; Random while in USB mode. VOL A Volume Increase VOL V Volume Decrease TUN A Track Up / Tune Up / Fast Forward TUN V Track Down / Tune Down / Reverse Radio Operation 't A. SEL button 1. Pressing this button in succession results in the following menu options: volume, bass, treble, balance, fader, display.
'IJ1'J Radio Operation • D. Presets. Upon finding a desirable station, hold either the preset 1, 2, 3, or 4 down for 2 seconds to store. E. Tuning. A short press of the TUN " or TUN v button results in a search of the station of the station of next sufficient signal strength. A long press results in manual tuning mode, allowing you to search one odd digit frequency at a time. USB Operation f Note: USB slot is for USB sticks only.
Bluetooth Operation 0 Your media device must incorporate the Bluetooth option in order to stream music. A. To pair your Bluetooth device, press the Mode button on the stereo until BT MUSIC appears. B. Next, go to settings on the Bluetooth device and turn the Bluetooth option to "on". C . Pick the "INFINITY" option on your Bluetooth enabled device (please note that if you are prompted for a password, the code entered will be "1234". If your stereo does not immediately pair, press preset 3.
Installation A mounting gasket has been added inside the package for convenience. Trace along the outside edge and this will be your cutout. Mounting Illustration 2. Use the bracket and screw to fix the unit. Install the U bracket behind the unit, using two nuts per bolt for ultra hold. 1. Please install this unit in the place you prefer.
Troubleshooting *Note: In many respects, a stereo acts much like a computer and occasionally requires a reboot. In the unlikely event of product malfunction, a reset can usually fix the issue. A reset is accomplished by holding the Mode and Preset l button simultaneously until the unit turns off. Issue Cause Solution No power 1. Incorrect wiring 2. Fuse is blown 3. Low battery voltage 1. Double check wiring 2. Replace fuse 3. Check voltage of vehicle battery with multimeter.
