Owner's Manual

Installation
A mounting gasket has been added inside the package for convenience. Trace along
the outside edge of the gasket thus revealing your cutout.
Mounting Illustration
1. Avoid installing stereo
below cupholders!
Make sure mounting
substrate is flat to avoid
flexing of the plastic.
2. Use the back bracket and
studs to affix the unit. Install
the U bracket behind the unit,
using two nuts per bolt for
ultra hold .
3. To avoid possible water
ingress into wire harness
area, route the harness in
the downward direction
as shown above .
NO.
PART DESCRIPTION
1
RADIO
2
MOUNTING PLATE
3 MOUNTING STUDS
4
JAMB NUTS
5
MOUNTING BRACKET
6 SPRING WASHER
7
OUTER NUTS
Instructions:
1. Install jamb nuts ( 4) loosely on mounting
studs (3), so they will not touch mounting
brackets (5) when installed.
2. Slip mounting bracket (5) on and make
flush with mounting surface (2).
DO NOT TIGHTEN
3. Snug spring washer ( 6) and outer nuts (7)
against mounting plate (2).
DO NOT TIGHTEN
4. Positionjamb nuts (4) approximately
1/ 16" from mounting bracket.
5. Tighten outer nut s (7) completely.
3