Owner's Manual

Installation
A mounting gasket has been added inside the package for convenience. Trace along
the outside edge
of
the gasket thus revealing your cutout.
Mounting Illustration
1.
Avoid installing stereo
below cup holders!
Make sure mounting
substrate is flat to avoid
flexing
of
the plastic.
2.
Use
the back bracket and
studs to affix the unit. Install
the U bracket behind the unit,
using two nuts
per
bolt for
ultra hold.
Wire Configuration
6PREMOTE
CONTROL
(ANTJACK)L__jlWDLt----'
12P
CONNECTOR
(REM)
_____
BL_UE_....J
(ACC)
(GROUND)------===.:..:____.
WHITE
(
FRONT
LEFT
)
WHITE/BLACK
GREEN
(REAR
LEFT)
GREEN/BLACK
GRAY
GRAY/BLACK
VIOLET
VIOLET/BLACK
3.
To
avoid possible water
ingress into wire harness
area, route the harness in
the downward direction
as shown above.
(FRONT
LINE
OUT)
(REAR
LINE
OUT)
(AUX)
(SUBWOOFER)
(USB)
(FRONT RIGHT
)
(REAR
RIGHT)
NOTE:
When wiring, the red lead is recommended to be wired to ACC/ignition power lead.
3