Owner's Manual

INSTALLATION BULLETIN
To avoid possible water ingress into wire harness area, route the harness
in the downward direction as shown below on the left . Do not route the
harness in the upward direction as shown on the right.
Installation Instructions
8
NO.
PART DESCRIPTION
1 RADIO
2
MOUNTING PLATE
3 MOUNTING STUDS
4 JAMB NUTS
5 MOUNTING BRACKET
6
SPRING WASHER
7
OUTER NUTS
Instructions:
1. Install jamb nuts (4) loosely on mounting
studs (3), so they will not touch mounting
brackets (5) when installed.
2. Slip mounting bracket (5) on and make
flush with mounting surface (2).
DO NOT TIGHTEN
3. Snug spring washer (6) and outer nuts (7)
against mounting plate (2).
DO NOT TIGHTEN
4. Po sition jamb nuts ( 4) approximately
1/16" from mounting bracket.
5. Tighten outer nuts (7) completely.