Owner's Manual
Installing the 6.5" woofers
The woofers are usually mounted
in
your vehicle's factory woofer
locations. which are typically in the doors (front)
or
side panels
(rear). If you choose
to
mount
them in a custom location, mounting
them higher will raise the soundstage, while mounting them
lower
In
the doors will provide excellent bass response.
To mount the woofer
to
the mounting location, place the driver
against the mounting surface and
use
the supplied screws
to
secure.
(:
\
o:
t-~~
---.
~
:::
-
or
f~J.
I
0
--
~ -
'---.
........
TIPS:
•
It
Is
recommended
to
use the included insulating material
between the mounting surface and the mounting ring
of
the
woofer
to
absorb vibrations
and
help produce the cleanest
sound possible.
• Use the included speed clips behind the mounting surface
to
provide a
way
to
secure the screws,
1f
necessary
• Take care
not
to
overtighten the screws, to prevent damage.
If mounting
In
the
door
panel, make sure the magnet protrusion
does
not
interfere with
window
or
door
latch operation.
•
In
a custom location,
if
the woofer Is visible, use the included
decoration nng and gille
to
cover the screws and protect the
speaker cone.
• If mounting in a custom enclosure that you manufacture.
recommend that the sealed volume
of
the enclosure
is
more
than 0. 7
cubic
feet (>20L).
WIRING THE INIFINITY BeTA Be621
SPEAKERS
All connections from the amplifier and
to
the speakers are made
through the included crossovers.
Accessing the terminals
in
the crossovers
Slide the Allen wrench into the hole
in
the front panel
of
the
crossover. then gently
to
pry
up
the cover
of
the crossover.
Remove cover.
Connecting the speakers
to
the crossover
• Use the Allen wrench
to
open the terminals
by
turning the
setscrews counterclockwise.
• Insert the tweeter wires into the
'OUT'
terminals marked
'TWEETER'. and the woofer wires into the terminals marked
"WOOFER
'.
~---OUT-----.
WOOFER TWEETER
0000
+
+
• Secure the connections
by
using the Allen wrench
to
tighten
the setscrews
by
turning them clockwise.
Connecting the amplifier to the crossover:
bi-amping
The Infinity
Be
TA Be621 crossover lets you bi-
amp
the system
(powering the tweeters independently
of
the woofers). To
bi-amp
:
• Slide the
'Bl
-
AMP'
switch
to
'
on
'
Bl-AMP
)
ON OFF
• Connect a single amplifier
output
channel with speaker wire
to
each crossover
'IN'
terminal (use the terminals marked
'WOOFER/2-WAY' for the woofers. and 'TWEETER' for the
tweeters) .
.----------IN------~
WOOFER/2-WAY TWEETER
0000
+
+
~-----
-
Bl-AMP-
--
---_,
• Use the included Allen wrench
to
tighten and secure.